Ask IRWIN

What is the recommended bit speed for flat bits? I am sure that the speed varies by bit diameter and wood species

We have a recommended turning speed of 1500 - 2000 RPM on the IRWIN Speedbor wood boring bits, never exceed 2500 RPM. A good rule of thumb to follow on any drilling tool is the larger the bit the slower the speed. I'd recommend the 1/4" at a max 2000 RPM and slow the speed gradually as you move up to the 1-1/2" size.

Ask IRWINClick a question below to view the answer.

Chisels

Can IRWIN chisels be re-sharpened? If so, what's the best angle to re-sharpen at?

Circular Saw Blades

I am crosscutting oak veneer plywood on a table saw, and the veneer is chipping on the backside. What type of blade would you recommend to cleanly cut across plywood?

Drill Bits

Extractors

What is the difference between a nutsetter that has a standard hex design vs. one that has a lobular design?

Fastener Drives

I recently purchased a cargo trailer. There are 2 screws that hold the license plate bracket on. I cannot identify the screw drive type. At first glance I thought it was a Torx head, but upon closer examination and trial I noticed that the star has 8 points instead of 6. The points are not as prominent as a Torx. Can you identify it?

All Tools

Tools by Trade

Ask IRWIN

What is the recommended bit speed for flat bits? I am sure that the speed varies by bit diameter and wood species

Chisels

Circular Saw Blades

Drill Bits

Extractors

Fastener Drives

Hand Saws

Levels

Marking Chalk

Pliers and Wrenches

Snips

Tape Measures

Taps, Dies, & Sets

Utility Knives & Blades